2007-2018 Jeep Wrangler JK/JKU A-Pillar Phone & Radio Mount | 1" RAM-Compatible Ball

Jeep Wrangler JK/JKU A-Pillar Phone & Radio Mount

Add a 1-inch RAM-compatible mounting point to your 2007-2018 Jeep Wrangler JK or JKU using the factory upper A-pillar bolt location. It gives you a clean place to mount a phone, GPS, GMRS or HAM radio without adding another suction cup or vent clip to the cabin.

Fitment: 2007-2018 Jeep Wrangler JK and JKU. Installs on either the driver or passenger side.

Why Use an A-Pillar Mount?

The factory upper A-pillar bolt gives you a solid, easy-to-reach mounting location while keeping the dash itself untouched. Remove the factory bolt, install the FireCrateUSA mount with the included socket-head bolt, then attach your compatible 1-inch ball arm and device holder.

What Can I Mount?

• Phone holders
• GPS units
• GMRS or HAM radio accessories
• Other accessories that use a compatible 1-inch ball arm or socket

Important: This listing includes the A-pillar ball mount and mounting bolt only. RAM arm, phone holder, GPS mount, radio holder and electronics are not included.

Fitment and Installation

• Fits: 2007-2018 Jeep Wrangler JK and JKU
• Location: Driver or passenger upper A-pillar
• Mounting point: Existing upper A-pillar to windshield-frame bolt location
• Drilling: No new mounting hole is required
• Install guidance: Tighten lightly snug, approximately 4 ft-lbs. Do not overtighten.

Built by FireCrateUSA

The mount body is 3D printed in PETG by FireCrateUSA. The compact design gives you a practical mounting point without a large dash rail or permanent modification.

What's Included?

• 1 x FireCrateUSA 1-inch A-pillar ball mount
• 1 x socket-head mounting bolt

Jeep JK/JKU A-Pillar Mount FAQ

Does it fit both JK and JKU?
Yes. It is designed for 2007-2018 Wrangler JK and JKU models.

Can I install it on either side?
Yes. It can be installed on the driver or passenger A-pillar.

Does it include a RAM arm or phone holder?
No. This is the vehicle-side 1-inch ball mounting point plus the installation bolt.

Does it require drilling?
No new mounting hole is required. It uses the existing upper A-pillar bolt location.

What size ball is it?
The ball is 1 inch and is intended for RAM-compatible 1-inch mounting arms and accessories.

---

---